A32NX FlyByWire Overhead
-
- Posts: 16
- Joined: Tue Nov 23, 2021 9:58 am
- Location: Madrid
Re: A32NX FlyByWire Overhead
cokpit door video........ light works
adirs........................ trn and actuate ok...lights im not sure
flight computers ......... light works ....... i mean not actuate
evacuate .................. works
EMGCY ELEC............... light ok, actuate partially
gpws......................... works til I can test
rcrdr........................ light ok
oxigen...................... ok
calls......................... perfect
wiper capt.................. dead
fire and apu test........... perfect
hyd............................ lights ok actuate ok
fuel........................... all works except model selector. in my oppinion, when you turn the fuel pumps to off, the engines shut down too quickly, these engines can run only with the gravity during hours....
elec............................ perfect except...when you push the idg button, the gen dead til ground reset. by mant staff
air condition.................. perfect
anti ice........................ ok
probe........................... light ok, but dont' actuate
cabin press..................... lights ok. works 25%....in man mode you can open a close de outflow valve....f.e.
ext lights....................... ok
apu................................ ok
int lights ...................... 50%
signs............................ ok
rmp.............................. vhf ok rest dead
acp............................... like in the past
fligh ctrls........................ lights ok....no actuation
cargo vent........................ dead
cargo smoke .................... ok
vent............................... lights ok
man start........................ lights ok, but works? in my oppinion no
wiper ............................ yo turn it on, but imposible to stop
i hope this help you a bit
regard luis
adirs........................ trn and actuate ok...lights im not sure
flight computers ......... light works ....... i mean not actuate
evacuate .................. works
EMGCY ELEC............... light ok, actuate partially
gpws......................... works til I can test
rcrdr........................ light ok
oxigen...................... ok
calls......................... perfect
wiper capt.................. dead
fire and apu test........... perfect
hyd............................ lights ok actuate ok
fuel........................... all works except model selector. in my oppinion, when you turn the fuel pumps to off, the engines shut down too quickly, these engines can run only with the gravity during hours....
elec............................ perfect except...when you push the idg button, the gen dead til ground reset. by mant staff
air condition.................. perfect
anti ice........................ ok
probe........................... light ok, but dont' actuate
cabin press..................... lights ok. works 25%....in man mode you can open a close de outflow valve....f.e.
ext lights....................... ok
apu................................ ok
int lights ...................... 50%
signs............................ ok
rmp.............................. vhf ok rest dead
acp............................... like in the past
fligh ctrls........................ lights ok....no actuation
cargo vent........................ dead
cargo smoke .................... ok
vent............................... lights ok
man start........................ lights ok, but works? in my oppinion no
wiper ............................ yo turn it on, but imposible to stop
i hope this help you a bit
regard luis
-
- Posts: 52
- Joined: Wed Sep 23, 2020 4:44 pm
Re: A32NX FlyByWire Overhead
Hi Luis,
Thank you for this very exhaustive review. So that I can work properly, could you :
- Do not report malfunctions due to the simulator itself
- List only the problems and describe the operating logic on the real airplane
In this way we will improve these instruments
THX, Scarabée
Thank you for this very exhaustive review. So that I can work properly, could you :
- Do not report malfunctions due to the simulator itself
- List only the problems and describe the operating logic on the real airplane
In this way we will improve these instruments
THX, Scarabée
-
- Posts: 16
- Joined: Tue Nov 23, 2021 9:58 am
- Location: Madrid
Re: A32NX FlyByWire Overhead
ok
willco
regards
willco
regards
-
- Posts: 52
- Joined: Wed Sep 23, 2020 4:44 pm
Re: A32NX FlyByWire Overhead
Hi pilots,
I just updated and submited the ATC/TCAS panel.
You can download it in the post 2 (following).
Scarabée
I just updated and submited the ATC/TCAS panel.
You can download it in the post 2 (following).
Scarabée
Re: A32NX FlyByWire Overhead
Here is an issue report of one of my friends with multi-monitor setup using your Overhead Panel since some weeks:
1.) The Landing Light Switches stuck until using an assigned hardware switch, then they are free for switching with the mouse.
2.) Exterial Power AVAIL light is sometimes dark, even it´s available, after restarting MSFS it´s lit again.
After this restart, when pushed, the Exterial Power is working but it still says AVAIL not ON.
3.) Sometimes Upper ECAM shows "STROBE LIGHT OFF", even they are AUTO or ON.
The issue I realized at my setup is, that after Strobe Lights were ON, I can switch to AUTO but when trying to switch back to off, the switch flips three times between ON and AUTO, then finsally to OFF.
Kind regards,
Herbert:
1.) The Landing Light Switches stuck until using an assigned hardware switch, then they are free for switching with the mouse.
2.) Exterial Power AVAIL light is sometimes dark, even it´s available, after restarting MSFS it´s lit again.
After this restart, when pushed, the Exterial Power is working but it still says AVAIL not ON.
3.) Sometimes Upper ECAM shows "STROBE LIGHT OFF", even they are AUTO or ON.
The issue I realized at my setup is, that after Strobe Lights were ON, I can switch to AUTO but when trying to switch back to off, the switch flips three times between ON and AUTO, then finsally to OFF.
Kind regards,
Herbert:
Herbert Puukka
MSFS - CRJ, X-Plane - Citation X, Air Manager, FSHud, Navigraph
MSFS - CRJ, X-Plane - Citation X, Air Manager, FSHud, Navigraph
-
- Posts: 52
- Joined: Wed Sep 23, 2020 4:44 pm
Re: A32NX FlyByWire Overhead
Hi Herbert,
Thanks for your report.
Could you specify the versions (A32NX FBW, AirManager, and the instruments) ?
- "EXTERNAL POWER ON","Bool"
- "EXTERNAL POWER AVAILABLE","bool"
- "L:LIGHTING_STROBE_0","num"
- "LIGHT STROBE","bool"
- "L:STROBE_0_AUTO","num"
To put the strobe "off", the only solution that I have found for the moment is to double click downwards ... Attention, on the "auto" position the strobes only light up when the main gear strut is not compressed.
Scarabée
Thanks for your report.
Could you specify the versions (A32NX FBW, AirManager, and the instruments) ?
I use them every day without problems ... Can you make sure that in the first position, they come out well ? Then for the lighting there is a delay (5-8 seconds) before switching on ...1.) The Landing Light Switches stuck until using an assigned hardware switch, then they are free for switching with the mouse.
Could you give me an example location so that I can show the bug? Can you monitor the values of these two variables:2.) Exterial Power AVAIL light is sometimes dark, even it´s available, after restarting MSFS it´s lit again.
After this restart, when pushed, the Exterial Power is working but it still says AVAIL not ON.
- "EXTERNAL POWER ON","Bool"
- "EXTERNAL POWER AVAILABLE","bool"
Can you reproduce the error or does it only appear sometimes ? Can you monitor the values of these three variables:3.) Sometimes Upper ECAM shows "STROBE LIGHT OFF", even they are AUTO or ON
- "L:LIGHTING_STROBE_0","num"
- "LIGHT STROBE","bool"
- "L:STROBE_0_AUTO","num"
To put the strobe "off", the only solution that I have found for the moment is to double click downwards ... Attention, on the "auto" position the strobes only light up when the main gear strut is not compressed.
Scarabée
Re: A32NX FlyByWire Overhead
I have the same problems!
Thank you though for the great overhead!
I want to run it via a network with Air Player on a touchscreen panel but:
The landing lights don't move
Ext. power is not iluminated
And a lot of gauges show white text OFF while showing dark / nothing in the sim.
Greetings,
Robert
Thank you though for the great overhead!
I want to run it via a network with Air Player on a touchscreen panel but:
The landing lights don't move
Ext. power is not iluminated
And a lot of gauges show white text OFF while showing dark / nothing in the sim.
Greetings,
Robert
-
- Posts: 16
- Joined: Tue Nov 23, 2021 9:58 am
- Location: Madrid
Re: A32NX FlyByWire Overhead
yes....I also have similar malfuctions... like "main GENs"
regards
Luis
regards
Luis
-
- Posts: 52
- Joined: Wed Sep 23, 2020 4:44 pm
Re: A32NX FlyByWire Overhead
Hi pilots,
First, please indicate your FBW version.
I have updated the instruments to be compatible with the 0.7.4 stable version. But ! Submission must be reviewed by siminnovation and if accepted they will be online on next shop update (once a month). So, be patient... if you have online version, it will be updated automatically.
I'm working on development version and the overhead will soon have :
- "Opacity" instead "visible" lights logic (so progressive light)
- Sunlight (with the Toddimus831 code)
- Backlight
Stay tune
Scarabée
First, please indicate your FBW version.
I have updated the instruments to be compatible with the 0.7.4 stable version. But ! Submission must be reviewed by siminnovation and if accepted they will be online on next shop update (once a month). So, be patient... if you have online version, it will be updated automatically.
I'm working on development version and the overhead will soon have :
- "Opacity" instead "visible" lights logic (so progressive light)
- Sunlight (with the Toddimus831 code)
- Backlight
Stay tune
Scarabée
Re: A32NX FlyByWire Overhead
Thank you!
A development version would be great!
Looking forward!
Gr.
Robert
A development version would be great!
Looking forward!
Gr.
Robert