Hi Keith,
I am not understanding your bezel dimensions -
Ralph I am not sure. The CockpitSimParts DU frame, right in the pic, is 178x173. The frame I got from another source( don't rem where) is 188x170
So I looks like it is a 7"x 7" square screen. 178mm x 178mm
For example, a 188 x 170 would not be able to be used with a 178x178 display screen.
Or did you mean 178 x170 ?
Also, I would appreciate the measurements of the OUTSIDE of the frame as well. The cockpitsimparts one is the most relevant.
It appears from what you are saying that the visible area - the open section of the bezel on the CSP bezel is 178x173 ?
Karls one I am not concerned about, but thanks for the link . The CSP one would act as a benchmark. I am not wanting to make one !. It is to assess the size requirements of MODERN LCD display units to use behind dual DUs and also to see where measurement have either been shaved or can be.. It will almost certainly be possible.
It would be appreciated to get the outside dimensions of that one and also if you confirm 178x173 and, if so, in which orientation. The base of the panel, as you know, is the one with the simulated handle hinge in. If it is 178 x 173, for example, is it 178 Wide or 173 wide ?, and also please, as said, the outer width and height in relation to the base (lower edge) and if the bezel width (the frame width between the open inner view area and the outer side) is equal on both sides ?
Cheers.
Joe