Hello
I want to know haw to calibrate an analog imput because I use only 90 degrees of the potentiometer
Thanks
Analog calibration
Re: Analog calibration
I guess with calibrate you mean that you want to use for example 0 - 0.5 from the range of 0 - 1, and that this 0.5 has to become 1.
That's just simple mathematics: 1 / 0.5 * adc_value
Or the same result: 2 * adc_value
That's just simple mathematics: 1 / 0.5 * adc_value
Or the same result: 2 * adc_value
Re: Analog calibration
Thx now I have a range of 90degrees of the potentiometer starting from the one end.
Another question and thx again.
To move the 0 from potentiometer let's say about 30 degrees?
Another question and thx again.
To move the 0 from potentiometer let's say about 30 degrees?
Re: Analog calibration
That's again just mathematics
Have a good look at the previous one, and you should be able to solve it.
Have a good look at the previous one, and you should be able to solve it.
Re: Analog calibration
If not then let us know.
Re: Analog calibration
Hello
My throttles are working super fine thanks to you.
And last this is the cherry on the cake
For ZIBO motorized throttle
I want to use servos from R/C
To activate the servo I need AT in state on+ N1 or SPEED or LEVEL CHANGE in state 1.
THIS IS THE BIG QUESTION FOR ME
ANYWAY THANKS AGAIN
My throttles are working super fine thanks to you.
And last this is the cherry on the cake
For ZIBO motorized throttle
I want to use servos from R/C
To activate the servo I need AT in state on+ N1 or SPEED or LEVEL CHANGE in state 1.
THIS IS THE BIG QUESTION FOR ME
ANYWAY THANKS AGAIN
Re: Analog calibration
I believe that @Keith Baxter was working on something like this?