Hello,
one question again.
The frequency is displayed very well (active and standby) but I would like to install a rotary encoder to set the frequency.
I've not found any Rotary Encoder for the frequency in the Hardware Instrument-Panel.
Have a nice weekend!
Chris
Arduino Mega COM / NAV Panels - character display
-
old pilot guy
- Posts: 30
- Joined: Wed Dec 25, 2019 8:55 pm
Re: Arduino Mega COM / NAV Panels - character display
Here is my SIFF file I used on the Zibo 737-800. I have 9 Max 7219 displays. 2 are daisy-chained at a time. Also put a 100uf capacitor between each 5V+ and ground leads. External 5V power supply to each Max7219, not daisy-chained..
Built a box without any special tools. Placed an Arduino Mega2560 inside. Just a usb connection and done. You can change the brightness in the LUA. Max7219's not as bright as photo shows.
Hope this helps.
Regards Old Pilot Guy
Built a box without any special tools. Placed an Arduino Mega2560 inside. Just a usb connection and done. You can change the brightness in the LUA. Max7219's not as bright as photo shows.
Hope this helps.
Regards Old Pilot Guy
CENTER PEDESTAL BRIGHT 7-1-22 - COM1, COM2, NAV1, NAV2, xsponder FINAL 7-2-22-.siff- (13.18 KiB) Downloaded 84 times