I'm having a problem using the above ADF receiver. It is one of few that accept that there are still some NDBs that transmit using tenths of a Khz.
It will switch on and off. I can change the 10Khz setting or the 0.1Khz settings using the mouse (or knobster) but I can't find a way of changing the 1Khz or 100Khz settings. With the mouse I hover over the centre of the knob or the outer part of the knob.
So, for example if the freq shown is 346.0 I can change the 4 or the 0 but the 3 and 6 don't work. If I needed 1356.0 I don't think I could get that.
Hope someone has an idea about this. Cheers.
Collins Radio ADF
Re: Collins Radio ADF
Hi flyatr,
I struggled with this last night, checked again before writing to you and then, after writing, checked again and would you believe it is working.
Sorry for bothering you.
Regards
Roger
I struggled with this last night, checked again before writing to you and then, after writing, checked again and would you believe it is working.
Sorry for bothering you.
Regards
Roger