Here the test. I downloaded it from wiki and tried again. No response.
I installed it with an older installer and it then works. Here is the output of the installer with the latest version:
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% -0.00s
avrdude: Device signature = 0x1e950f (probably m328p)
avrdude: reading input file "program.hex"
avrdude: writing flash (28676 bytes):
Writing | ################################################## | 100% 4.62s
avrdude: 28676 bytes of flash written
avrdude: verifying flash memory against program.hex:
avrdude: load data flash data from input file program.hex:
avrdude: input file program.hex contains 28676 bytes
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 3.68s
avrdude: verifying ...
avrdude: 28676 bytes of flash verified
avrdude: safemode: Fuses OK (E:00, H:00, L:00)
avrdude done. Thank you.
Can't Make Arduino to work on AM 3.2
Re: Can't Make Arduino to work on AM 3.2
Just a long shot but do you need a later version of AM for the latest Arduino code to work.
Air Manager panels at https://www.experimentalsimavionics.com
Youtube Channel https://www.youtube.com/channel/UC8ZqXX ... kfZMq5BKig
Air Manager API Tutorial Video Series https://youtube.com/playlist?list=PLNr0 ... baT4gJKg5D
Youtube Channel https://www.youtube.com/channel/UC8ZqXX ... kfZMq5BKig
Air Manager API Tutorial Video Series https://youtube.com/playlist?list=PLNr0 ... baT4gJKg5D
Re: Can't Make Arduino to work on AM 3.2
Hey,
Just checked the latest wiki version with my Arduino Uno, and it seems to work fine.
How do you feel like doing a teamviewer session. Hopefully I can figure out the problem.
Also, bit of a stupid question, but is the 'Automatically connect to Arduino's' checkmark checked in the settings tab?
Corjan
Just checked the latest wiki version with my Arduino Uno, and it seems to work fine.
How do you feel like doing a teamviewer session. Hopefully I can figure out the problem.
Also, bit of a stupid question, but is the 'Automatically connect to Arduino's' checkmark checked in the settings tab?
Corjan
Re: Can't Make Arduino to work on AM 3.2
Yes, it is with the flag set!
Sure.. give me 5 min and I’ll setup the teamviewer entry!
Sure.. give me 5 min and I’ll setup the teamviewer entry!
Re: Can't Make Arduino to work on AM 3.2
whaty is your skype id Corjan?
Re: Can't Make Arduino to work on AM 3.2
A PM has been sent with my skype ID,
Corjan
Corjan