Installed Air Manager 4.1 BETA 18 on last Saturday.
Since then I could not run my MCP hardware driven by an Arduino MEAG Board to work with this version. None of the following did help
- stppping and starting the panel
- stopping and restarting Air Manager
- flashing the board from version 18
- disconnecting and reconnecting from USB
- rebooting the PC
I reverted back to BETA 17. Everything is running as usual again.
The update message showed a note about some arduino pins not driven correctly.
Are there incompatibilities that need some code changes to run BETA 18?
Paul
AM 4.1 Beta 18 not operational with Arduino MEGA
-
- Posts: 236
- Joined: Sun Feb 14, 2021 6:55 pm
Re: AM 4.1 Beta 18 not operational with Arduino MEGA
Hi,
Found the fault. I changed regex library, and the new one handled the regex string just a bit different.
Will push a new BETA 19 today, thanks for letting us know!
Corjan
Found the fault. I changed regex library, and the new one handled the regex string just a bit different.
Will push a new BETA 19 today, thanks for letting us know!
Corjan
-
- Posts: 236
- Joined: Sun Feb 14, 2021 6:55 pm
Re: AM 4.1 Beta 18 not operational with Arduino MEGA
@Corjan, I can confirm Beta 19 is OK.
AND, it even solves that long standing issue we have been searching for quite a while. I can now stop and restart the panel anytime and the ARDUINO is responsive on each panel restart.
Thank you
Paul
AND, it even solves that long standing issue we have been searching for quite a while. I can now stop and restart the panel anytime and the ARDUINO is responsive on each panel restart.
Thank you
Paul
Re: AM 4.1 Beta 18 not operational with Arduino MEGA
Hi,
Good to hear that is fixed.
Not sure why the reconnect would be fixed though, have not done anything there I think...
Corjan
Good to hear that is fixed.
Not sure why the reconnect would be fixed though, have not done anything there I think...
Corjan