Page 1 of 1
New to Air Manager and NOT a programmer/developer
Posted: Fri Apr 30, 2021 12:16 pm
by CubDriver_197T
Hoping someone can point me toward some help. While I am relatively capable in using tech, I am not a programmer or developer type.
Can someone point me to a tutorial that deals specifically with how install panels created in AM to aircraft in MSFS2020?
Thanks!
Re: New to Air Manager and NOT a programmer/developer
Posted: Fri Apr 30, 2021 12:24 pm
by Keith Baxter
Hi,
Welcome to the forum.
A general starting point would be spending some time watching Tony's tutorials. That should give you a good starting point
https://siminnovations.com/forums/viewt ... =14&t=2787
By going through the tutorials you get a basic knowledge and avert frustration on all sides.
Keith
Re: New to Air Manager and NOT a programmer/developer
Posted: Fri Apr 30, 2021 12:34 pm
by Sling
CubDriver_197T wrote: ↑Fri Apr 30, 2021 12:16 pm
Hoping someone can point me toward some help. While I am relatively capable in using tech, I am not a programmer or developer type.
Can someone point me to a tutorial that deals specifically with how install panels created in AM to aircraft in MSFS2020?
Thanks!
Hi and welcome to the forum,
I’m not sure I understand your question. AM panels are not installed in any sim aircraft. The AM panels exist in their own right and communicate with the sim.
Re: New to Air Manager and NOT a programmer/developer
Posted: Fri Apr 30, 2021 12:52 pm
by CubDriver_197T
I’m not sure I understand your question. AM panels are not installed in any sim aircraft. The AM panels exist in their own right and communicate with the sim.
Ah!! This was a point that I apparently didn’t understand. I have read thru the wiki documentation and either missed that or did not realize the reality of the situation.
When I get home, I’ll check out the tutorials mentioned and see what I can learn/figure out. Thanks for the tips, guys!