User Help
Posted: Sun Jun 13, 2021 6:38 pm
Hi,
I'm a newbie in Sim Innovation software, i want to migrate my setup with a few Flight Illusion gauges to FS2020.
My hardware is OK under P3D with FI driver, but with Air Manager, it si more complicated.
Is there anywhere a step by step for configuring this ?
Air manager r wks two times the same way, my gauges are sometimes working fine (never all together ), some seem not fully working (eg : heading with barber pole gauge seems not working in MSFS, Chronometer/clock : the digits are never on, needle and light OK ).
I can move the needles in Air manager, but in the sim, there is always almost one gauge not working. In this case, the former and the latter in the daisy chain can be OK.
Regards
I'm a newbie in Sim Innovation software, i want to migrate my setup with a few Flight Illusion gauges to FS2020.
My hardware is OK under P3D with FI driver, but with Air Manager, it si more complicated.
Is there anywhere a step by step for configuring this ?
Air manager r wks two times the same way, my gauges are sometimes working fine (never all together ), some seem not fully working (eg : heading with barber pole gauge seems not working in MSFS, Chronometer/clock : the digits are never on, needle and light OK ).
I can move the needles in Air manager, but in the sim, there is always almost one gauge not working. In this case, the former and the latter in the daisy chain can be OK.
Regards