DIY 3d printed mounts by Russ Barlow

Support for the SimWareKits Knobster in combination with Air Manager and Air Player

Moderators: russ, Ralph

Post Reply
Message
Author
Avenger
Posts: 64
Joined: Mon Dec 28, 2020 3:35 am

DIY 3d printed mounts by Russ Barlow

#1 Post by Avenger »

There is a youtube video where Russ introduces several 3d printed mounts for the knobster. But the link to the 3d designs is dead. The only design I could find is on the knobster wiki for a RAM mount. Can I get a link for the other designs? Of if not can the one on the wiki be used to attach to a base that can be clamped to a desk? Thanks.

Avenger
Posts: 64
Joined: Mon Dec 28, 2020 3:35 am

Re: DIY 3d printed mounts by Russ Barlow

#2 Post by Avenger »

Anybody still have the STL files? The video I am referring to is this one.

https://www.youtube.com/watch?v=pClANSv-g2k

User avatar
Ralph
Posts: 7867
Joined: Tue Oct 27, 2015 7:02 pm
Location: De Steeg
Contact:

Re: DIY 3d printed mounts by Russ Barlow

#3 Post by Ralph »

Maybe on something like Thingiverse, but I haven't seen them anywhere.

Avenger
Posts: 64
Joined: Mon Dec 28, 2020 3:35 am

Re: DIY 3d printed mounts by Russ Barlow

#4 Post by Avenger »

Ralph wrote: Sat Mar 20, 2021 3:13 pm Maybe on something like Thingiverse, but I haven't seen them anywhere.
Can a RAM mount be added to a base that can fit on a desk? The RAM STL is the only one you have on the wiki. I don’t know much about RAM mounts but from their homepage they mostly go on things like cars.

User avatar
Ralph
Posts: 7867
Joined: Tue Oct 27, 2015 7:02 pm
Location: De Steeg
Contact:

Re: DIY 3d printed mounts by Russ Barlow

#5 Post by Ralph »

Something like the RAM-B-238U maybe? There are a couple of different versions of this.

Avenger
Posts: 64
Joined: Mon Dec 28, 2020 3:35 am

Re: DIY 3d printed mounts by Russ Barlow

#6 Post by Avenger »

Does the ramball mount on the wiki page work with the current revision of the knobster? Also is it a B size or C size ramball? I’d rather have the stl’s of Russ’s designs but if this one fits, I’ll try it. Thanks.


User avatar
Ralph
Posts: 7867
Joined: Tue Oct 27, 2015 7:02 pm
Location: De Steeg
Contact:

Re: DIY 3d printed mounts by Russ Barlow

#8 Post by Ralph »

Yes it works with the current version (sorry for the late reply). I do not know which version of the Ram mount ball, it's 1 inch/25.4mm I think.

User avatar
gotBurner
Posts: 3
Joined: Fri Dec 14, 2018 12:18 pm

Re: DIY 3d printed mounts by Russ Barlow

#9 Post by gotBurner »

Came here to look for these STL mount files, notice the simwarekits site isnt active and the wiki doesn't have any STL files. Will work it out either way! Have fun folks! :D

Post Reply