dear simers . i m using a Pi4 8MB for displaying a gauge via air play for raspberry.....i installed the s/w to the card and displays my gauge perfect on the 3,5inch LCD.
i want to rotate the gauge i.e 90 clockwise and i dont know how to do it.
please help anyone knows.
regards Yorg
display rotation after installing imager with balena
-
- Posts: 4
- Joined: Thu Aug 26, 2021 2:41 pm
- Keith Baxter
- Posts: 4685
- Joined: Wed Dec 20, 2017 11:00 am
- Location: Botswana
Re: display rotation after installing imager with balena
AMD RYZEN 9 5950X CPU, Corsair H80I cooler, ASUS TUF GAMING B550-PLUS AMD Ryzen Mother Board, 32Gb ram Corsair Vengeance 3000Mh, MSI GTX960 4G graphics card
-
- Posts: 4
- Joined: Thu Aug 26, 2021 2:41 pm
Re: display rotation after installing imager with balena
Keith, thank you for your response ,
unfortunately i could not get any result.
again I say that when I flash the siminnovation sw to the sd card then the rotation samehow resets to landscape. i use Rb Pi 4 and a 3,5 inch display .
is any command that i can write before the boot or something else that i miss
Thank you again
unfortunately i could not get any result.
again I say that when I flash the siminnovation sw to the sd card then the rotation samehow resets to landscape. i use Rb Pi 4 and a 3,5 inch display .
is any command that i can write before the boot or something else that i miss
Thank you again
Re: display rotation after installing imager with balena
There's nothing special with our image, it's the same as the image your download from the Raspberry Pi website. The only difference is that our software is pre-installed.