Hi.
I am new to AM/AP and have problems getting an arduino to work.
Installed AM, flashed a Arduino mega, then added the device.
Then i downloaded the free 172 cessna panel, went to the adf instument settings and under Hardware i could select my arduino and the pins. Startet fsx on the same machine, run the panel, fine.
Panel shows data from fsx, the arduino is recognized i can turn the rotary encoder and the adf turns.
Now i copied the panel to my AP-raspberry. It also showed up after starting the panel. Then i added the arduino device to airplayer and in air, plugged the arduino into the pi i was able to see it after a few seconds in AM. But when i go to instrument settings under hardware i am not able to select anything. The dropdown is just not visible.
Any ideas
Arduino in AP on PI not working, work fine in AM
Re: Arduino in AP on PI not working, work fine in AM
You'll have to wait until version 4.1, sorry.
Re: Arduino in AP on PI not working, work fine in AM
I am a bit sad, as i just spent 100€ and the feature, which was prominent here: https://www.siminnovations.com/index.ph ... icle&id=21 is not possible.
But ok, seems, like i have to wait
Is there an estimate for 4.1 or an AP Pi beta i can give a try?
I just made a video for my problem:
https://youtu.be/sTw69GrBom4
But ok, seems, like i have to wait
Is there an estimate for 4.1 or an AP Pi beta i can give a try?
I just made a video for my problem:
https://youtu.be/sTw69GrBom4
Re: Arduino in AP on PI not working, work fine in AM
As a temporary solution you can use the pin numbers in the script, instead of named hardware.
Re: Arduino in AP on PI not working, work fine in AM
Hi Ralpph,
Can you explain a bit more? Did not get it.
Which script & where?
Best regards,
Christian
Can you explain a bit more? Did not get it.
Which script & where?
Best regards,
Christian
Re: Arduino in AP on PI not working, work fine in AM
After a bit of searching i found this video, which i guess will help me
https://youtu.be/rIbLCEpWdyk
https://youtu.be/rIbLCEpWdyk
- Keith Baxter
- Posts: 4685
- Joined: Wed Dec 20, 2017 11:00 am
- Location: Botswana
Re: Arduino in AP on PI not working, work fine in AM
Hi and welcome.Witzman wrote: ↑Tue Sep 14, 2021 10:49 pm After a bit of searching i found this video, which i guess will help me
https://youtu.be/rIbLCEpWdyk
Just two pointers if you have not found them that are great for newbie help.
Tony's videos
https://www.forums.siminnovations.com/v ... =14&t=2787
The API
http://siminnovations.com/wiki/index.ph ... _Logic_API
Keith
AMD RYZEN 9 5950X CPU, Corsair H80I cooler, ASUS TUF GAMING B550-PLUS AMD Ryzen Mother Board, 32Gb ram Corsair Vengeance 3000Mh, MSI GTX960 4G graphics card