RPI Communication Problem

[SimPassion]

Hello Cherokee83

you'll have to install putty and set a connection to your Rasp Pi knowing its IP address
once connected, use linux bash command to go to "/root/Air Player" folder and do an archive in tar/zip or whatelse format
then download to your PC to send to Corjan

the best way if you are not aware with this is to use a software like WinSCP (free) set a connect with SSH protocol (port 22)
then copy the "/root/Air Player" folder on your PC and archive it from this location

I have no more Rasp Pi to copy/past commands for you, sorry

Best regards
Gilles

[Cherokee83]

Hello Cherokee83

you'll have to install putty and set a connection to your Rasp Pi knowing its IP address
once connected, use linux bash command to go to "/root/Air Player" folder and do an archive in tar/zip or whatelse format
then download to your PC to send to Corjan

the best way if you are not aware with this is to use a software like WinSCP (free) set a connect with SSH protocol (port 22)
then copy the "/root/Air Player" folder on your PC and archive it from this location

I have no more Rasp Pi to copy/past commands for you, sorry

Best regards
Gilles

Thanks Gilles!
I'll try to do it and follow the instructions you gave me

[Ralph]

We can do that Skype session tomorrow. Probably a lot easier

[Corjan]

Hey,


We have been pushing instrument to the Raspberry Pi all day, and happy to say that we indeed found a crash.
This should be resolved in the latest BETA.

If you have installed the BETA version before and have the Pi connected to the internet, it should update to the latest BETA on Pi boot.

I will upload a new complete SD card image tonight though, just in case.


Corjan

[Corjan]

There is also a disk image available now, probably a safer way to upgrade:
https://siminnovations.com/wiki/index.p ... ry_Pi_BETA


Corjan

[Cherokee83]

Hi,

I already tried using the latest beta version of Air Player Raspberry and was able to transfer the guages on my RPI but the screen was blinking on and off maybe because of the error I am experiencing with the AM3.2 beta version

Thanks for the help!
Cherokee83

[Ralph]

The screen itself or the image itself. I mean, maybe the monitor cable isn't connected properly, maybe it's almost loose.

[Cherokee83]

Yes you were right Ralph hehe

[Huberflight]

Hi all,

i have the same Problem that is described bevor. When I load one Instr. to my PI 3b+ it works when I will load another one. It will disconnect the PI from Air Manager and no further communication is possible.
Only a new flashing of the SD Card works. But then the "Devil Cycle" starts from the beginning .

[Ralph]

Are you using default instruments or an instrument you've created yourself?