Sim Innovations Forums

The panels that display properly on the Air Manager 4, when cloned to Air Player 4 are missing some instruments. I've been testing cloning/creating new panels in Air Player 4, and narrowed down these occurrences to the instruments which I've "cloned" in the past. They are simply not visible in panels.

Has anyone experienced similar issue?

Please upload your custom instruments through the Create / Edit tab.

Will do. Thank you, Ralph!

It's something we had to build in last-minute. We still have to make videos and documentation for this. We're not 100% sure if it'll remain like this, but it will for now.

Tried the method. Found the following condition:

If I select "start the panel automatically when starting Air player", the panels automatically start ok, but the initialization is incorrect resulting wrong status of the panel being generated.

If I select "Start the panel automatically when switching to aircraft", and tick any particular choice, the Air Player will not load the panel when the aircraft is changed. When I check the config back in AM, the tick is not there anymore.

Here is a link to a video explaining the situation

https://drive.google.com/file/d/1L9c3B ... M6bY67kE_G

Freedom

For the procedure to upload the panels, you would have to go to the "Create/Edit” tab, select the panel and change the destination from “This computer” to “Air Player”. When you run the panel, the file will be loaded to the AP directory.

Suggest putting this in the wiki it’s no where to be found. Thanks.

Freedom

See my comment above about the wiki The video cannot be shown, it's set to private.

Fixed. please try again

https://drive.google.com/file/d/1L9c3B ... p=drivesdk

Aah I think I get it now. So basically Air Player does not store your settings for the panel start mode?