Hello everybody. I tried to create an image and the result was that the instruments jerked very strongly. Even with Linux it seems that you should do a "fresh" installation. However, I am not an IT expert either. I have created an installation process that has worked several times for me (...

And here at the end all the commands to copy again. sudo nano /boot/config.txt # Shutdown via hardware button dtoverlay=gpio-shutdown,gpio_pin=21, active_low=1,gpio_pull=up ------------------------------------------------------------------------------------ sudo raspi-config cd cd /home/pi/AirPlaye...

- In the SSH editor, change the directory in which the previously copied data is located. In my case enter:"cd /home/pi/AirPlayer4_32". IMG_5468.jpg - Now write: "sudo sh ./setup.sh" / Attention: The RPI needs a working internet connection! IMG_5469.jpg - At the end you will be a...

- Disable screen blanking. IMG_5459.jpg IMG_5460.jpg - Go back to the Main Menu and reboot the RPI. IMG_5461.jpg - Download the "Air Player Desktop Installation" image from the wiki page. - Create a folder with the SSH Editor in the directory "/home/pi/" e.g.: "AirPlayer4_32...

- If you want to turn off the RPI with a push button, open the boot config file with the command: "sudo nano /boot/config.txt". IMG_5454.jpg IMG_5455.jpg - And add the line: "dtoverlay=gpio-shutdown,gpio_pin=21,active_low=1,gpio_pull=up" on to shut down the RPI4 with the button o...

- Start the remote tool MobaXTerm.
- Create a new session (click on Session in the top left).
- Enter the IP address you found on NETGEAR Genie (192.168.0.104).

- Click ok.
- Login as: pi
- Password: RPI4

Hello nnyerges, hello all others, Sorry for the late reply, but I've been working abroad a lot in the past few months and I've been very busy. I am not a programmer or IT specialist. That's why I'm writing this guide "For Dummies" (Very easy ;) I have now figured out a way to install AirPl...

Ralph, Believe me.
Most times I don't know by myself what crazy things I'm doing

Now it's working and the problem was between my ears.
I had a cable connection Problem

Now I try to figure out to shutdown the AP via button.
The "old" LUA command didn't work anymore.

Hello everybody. After the update/ new installing of Air Player ARM on my RPI 3 Model B Rev 1.2. I would now like to use the GPIO pins again. They were previously connected to the RPI and works (a Rotary Switch and a Button). Wiki say's: "For I/O support on the Raspberry Pi run Bootloader as ro...

Hello Ralph, hello guda. Thanks for your fast reply. My situation now is that AirPlayer is running on my RPI and I have an Instr. installed. This communicates with X-Plane11 works (i had a network issue on top of all). Only the buttons are not running. Wiki say's: "For I/O support on the Raspbe...